Swimming Pool Shotcrete Sprayer Mobile Gunite Spray Machine
Product Details
Swimming Pool Shotcrete Sprayer
,Mobile Gunite Spray Machine
,Shotcrete Sprayer Mobile
slope reinforcement movabel design Shotcrete Sprayer for swimming pool
Shotcrete Sprayer
Maintenance of Shotcrete Sprayer:
1. If the clamping is not proper, the pressure will escape from the joint surface between the two plates, and carry out fine particles, producing dust at the side of the machine, the eruption of this fine sand and erosion of the sealing plate, so that it fails in a short time.
2. Sealing plate is not allowed to exist due to excessive clamping caused by excessive stress, otherwise it will cause excessive wear due to friction heating, the heat resistance limit of sealing plate is 110℃, generally not more than 80℃ in use is normal.
3. Each shift should clean the sealing plate and check for wear. If the rubber plate has been worn to such an extent that the steel inserts are flush with the surface of the rubber or there is air leakage from the air holes or feed holes, the sealing plate must be replaced. At this time, the rotating liner will directly contact the steel inserts, so that the sealing plate can not be fully pretightened to obtain an effective seal, and it will lose air tightness.
Parameters of Shotcrete Sprayer:
| Technical | Parameters | ||||
| Model | PZ-5 | PZ-6 | PZ-6F | PZ-7 | PZ-9/WSP |
| Throughput(m3/h) | 5-5.5 | 6 | 6-7 | 7 | 9 |
| Transport Distance (Tidal Spray) (m) | 200 | 200 | 200 | 200 | 200 |
| Applicable Material (Cement/Sandstone) Ratio | 1:3～5 | 1:3～5 | 1:3～5 | 1:3～5 | 1:3～5 |
| Applicable Material (Water/Ash) Ratio | ≤0.4～0.45 | ≤0.4～0.45 | ≤0.4～0.45 | ≤0.4～0.45 | ≤0.4～0.45 |
| Aggregate size (mm) | φ20 | φ20 | φ20 | φ20 | φ20 |
| Working Pressure (MPa) | 0.2～0.4 | 0.2～0.4 | 0.6～0.8 | 0.6～0.8 | 0.6～0.8 |
| Feeding height (m) | 1.1 | 1.1 | 1.1 | 1.1 | 1.1 |
| Rotor speed (r/min) | 11 | 11 | 11 | 11 | 11 |
| Motor Power (KW) | 5.5 | 5.5 | 7.5 | 7.5 | 7.5 |
| Motor speed (r/min) | 960 | 960 | 960 | 960 | 960 |
Operation Method of Shotcrete Sprayer:
After the preparation work is finished, the mixing material can be added to the machine. The machine operator should first open the main valve, the valve of the upper air duct opens 1/3 circles, and then adjust the air pressure of the lower air duct (to the cyclone) to about 0.05-0.1 MPa (depending on the delivery distance). Then the sprayer opens the nozzle valve and gives the wet rock surface. At this time, the operator can start the machine and start shotcreting. Now the working pressure is about 0.2-0.4 MPa. According to the water-cement ratio of mixtures and the length of conveying distance, after adjusting and determining the wind pressure to the cyclone, the upper air pipe valve is opened again until there is no more material leakage at the machine outlet.
Pictures of Shotcrete Sprayer:
Construction Site and Warehouse of Shotcrete Sprayer:
-
Orange ISO Cement Grout Pump Rational High Pressure Grouting Pump
Advanced Technology Rational Structure High Pressure Grouting Machine Universal High Pressure Grouting Machine Characteristics of High Pressure Grouting Machine: High pressure grouting machine is composed of main pump, belt gear system, seat, safety stop valve, motor (diesel engine) and special ... -
Green Gypsum Mortar Grout Pump 12 M3/H Floor Heating Backfill
high Power Hydraulic type Gypsum Mortar Pump floor heating backfill Gypsum Mortar Pump Application of Gypsum Mortar Pump: 1. In construction engineering: horizontal and vertical conveying mortar or large area coating; 2. In chemical sector and transport pulp in the pulp and paper industry raw ... -
SGS Mobile Concrete Pump Mini Concrete Pump Machine For Swimming Pool
Portable Design Environmental Mobile Concrete Pump for swimming pool Mobile Concrete Pump PLC automatic control system of Mobile Concrete Pump: The core components of the electrical part is PLC chip, some important electrical components using imported brands, contactors, relays and button switches ... -
Air Driven Concrete Spraying Machine 6m3/H Underground Shotcrete Sprayer
tunnel subway use air driven Concrete Spraying Machine long service life Concrete Spraying Machine Maintenance of Concrete Spraying Machine: 1. Anti-stick cavity and discharging elbow with anti-stick function, generally will not bond at work, but after the end of each shift should open the rotor, ...
